1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
Parts List
DESCRIPTION
QTY
ITEM
POLE 1"-4" (NOT SUPPLIED)
1
1
MNT-22-1
1
2
MNT-22-2
1
3
MNT-22-4
1
4
MNT-22-3
1
5
Helical Spring Lock Washer St. St.
#5/16
4
6
Plain Washer St. St. #5/16
4
7
Hex Cap Screw St. St. NC 5/16-18 x
1.25"
2
8
Hex Cap Screw St. St. NC 5/16-18 x 5"
2
9
Plain Washer St. St. #1/4
4
10
Helical Spring Lock Washer St. St.#1/4
4
11
Hex Nut St. St. NC 1/4-20
4
12
Hex Nut St. St. NC 5/16-18
2
13
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Wall Mounting
1. Align holes of item 2 with 4 studs on back plane
of the antenna (not shown).
2. Connect item 2 to the antenna with spring washers
(11), plain washers (10) and nuts (12).
3. Tighten the nuts at a torque of 30 Lbs x In.
4. Align item 3 with item 2 so teeth of
item 2 face teeth of item 3. Connect with
items 6, 7, 8, 13. Leave screw slightly loose.
5. Align item 5 with item 3 so teeth of item 5 face
teeth of item 3. Connect with items 6, 7, 8, 13.
Leave screw slightly loose.
6. Attach items 4, 5 to the pole as
illustrated, and connect them using
items 6, 7, 9.
7. Close screws (9) one and another in turn
up to tightening torque of each screw is
30...35 Lbs x In.
8. Distance betweeen ends of items 4, 5 on
one and another side must be equal.
NO SKEWNESS ALLOWED.
9. Adjust the desired angle, and fully tighten
the loose screws (paragraph 4, 5) at a torque
of 30 Lbs x In.
NOTE :
1. MOUNT SUITABLE FOR POLES
n
1"-4".
Mounting instructions - Azimuth and Elevation Adjustable Mount MNT-22
REV. 5
2
2
3
5
2
3
13
6
8
7
10
11
12
7
6
8
13
1
4
7
6
9
3
TEETH
TEETH
5
3
2
10. Make assemblies as illustrated in Fig. 1, 2.
11. Attach item 5 to the wall. Fasten it with screws 1/4"
or M6 using holes 'A'. (Screws not shown.)
12. Align item 3 with item 5 so teeth of item 3 face teeth
of item 5. Connect as illustrated in Fig. 3.
13. Adjust the desired angle, and fully tighten the loose screws
(paragraph 4, 5) at a torque of 30 Lbs x In.
.
WALL
5
A
