Marra Forni GFZ225, Use And Maintenance, Page: 18 / 28

9
6. 1 SET UP
• Carefully remove the packaging from the refrigerator;
• Remove the white PVC protection film from the stainless steel and all the protection used by the company
to reduce the risk of damage during transport;
•
Place the refrigerator on a flat level surface (use the adjustable feet). ( Fig. 1 )
Before use, clean the refrigerator with a clean, soft cloth or using a spray product. It is best to use little water
as it contains minerals which leave traces which are difficult to remove quickly.
•
Wash the tray and all the internal parts using anti-bacterial detergents to be found commercially;
• Remove the detergent with a soft sponge soaked in water and dry with a clean soft cloth .
Do not use abrasive detergents or powders which could make the finish opaque.
During these phases do not, as already stated, use great quantities of water which could damage electric
parts; a damp sponge is sufficient.
• Place the shelf supports inside the refrigerator, in the most suitable position for use, inserting each
support in to the holes on the base of the refrigerator and inserting the side tab in the appropriate place
on the sides or on the table supports ( Fig. 2 )
• Slide the shelf into the supports as shown in ( Fig. 2 )
• Slide into the appropriate runners, on the lower part of the refrigerator, the condensation waste tray and
for appliances which have automatic trays, connect the connector. ( Fig. 3 )
vaschetta
guida reggi vaschetta
Fig. 1 Fig. 2 Fig. 3 (see 13.2.4.1)
6. 3 PREARANGEMENTS
•
Check that the cables and the sockets are suitable for the power absorbed by the equipment.
THE USE OF ADAPTORS, MULTIPLE SOCKETS AND/OR EXTENSION LEADS IS FORBIDDEN
• Ensure that the upright and/or table refrigerator is not installed near to sources of heat like: ovens,
radiators, direct sunlight etc.
• Leave a space of at least
75
mm (
3
inches) between the back of the upright and/or table refrigerator and
any wall, to avoid the formation of condensation.
• The motor must be free of any obstacle which could hinder or limit the circulation through the condensing
unit situated on the top side part of the refrigerator.
• The distance between the refrigerator and the ceiling must not be less than 50 cm (19¾ inches).
•
Check that the environment has a sufficient change of air, in order to guarantee the cooling of the
condenser and the compressor unit.
GUIDE
Evaporation
condensing
water tray