Trawl Explorer | V5 | Servicing and Maintenance
1.
Inspect and clean the retainer ring groove, then put back the retainer ring
around the transducer.
2.
To insert the bottle back in the tube, place the bottle on the ground and push
the tube. The side of the tube that has a small curve goes first, on the side of
the end cap.
4.
Put back the housing.
1.
Put the bottle inside the housing.
2.
Slide the metal rod to block the bottle.
3.
Put back the shackle on the rod.
Replacing the Batteries
Before you begin
For this task you need the following tools:
O-ring lubricant
(Molykote 55
o-ring grease)
About this task
Only qualified Marport technicians can do this task.
Standard Trawl Explorer sensors have two batteries, mini Trawl Explorer sensors only have one.
Procedure
1.
Remove the old batteries.
|
65
