Marmitek IR455, Owner'S Manual

Page: 8 / 44

7. STOP : Simulates the STOP button (e.g. LIGHT - 2 - STOP) of the remote control. The
command is executed by the IR455.
8. VIEW ALL : Generates an overview of all your settings. See chapter 5.4 for more
information about the codes used.
9. CLEAR ALL : Clears all settings.
10. SET DEFAULT : Restores the factory settings.
11. GET : Reads the settings from the IR455. See chapter 5.4 for more information about the
codes used.
12. STORE : Saves the new settings to the IR455.
13. SAVE TO FILE : Saves your settings to a file.
14. GET FROM FILE : Retrieves the settings from a file you saved earlier.
5.2.1. The selection box LIGHT
With this option you can select the button on your B&O remote control you want to program.
Besides the buttons 1-16 you can also program the coloured buttons on the remote control.
GREEN = green button
RED = red button
YELLOW = yellow button
BLUE =
blue button
5.2.2. The selection box ADDRESS
With these selection boxes you can select the addresses (A1-P16) of the X-10 modules you
want to respond to this button on your B&O remote control.
Instead of an address (a combination of a letter and a number), you can also just select a
HouseCode (A, B… P). If you choose a HouseCode, all modules using this code will respond
to the button at the same time.
5.2.3. The selection box LEVEL (%)
When you have chosen an address under "ADDRESS" ( number, e.g. A1), you have
the following options:
100% =
ON
0% = OFF
5%, 10% ... 95% = directly set to the desired dim level.
ATTENTION: When using dimmer modules without a memory and switch modules (see
overview in chapter 6) you can only select 100% or 0%. If you select a dim value (e.g. 40%)
for these modules, the module will not respond.
When you have only chosen a HouseCode under "ADDRESS" (e.g. A), you have the following
options:
100% = ALL LIGHTS ON (only lamp modules with the HouseCode will respond)
0% =
ALL MODULES OFF (all modules with the HouseCode will respond)
8 MARMITEK