Pictured above is the B-size cutter blade assembly. The following information describes the changes
needed to switch from the B to A-size and B to C-size cutter assemblies. Refer to the color codes on page
four to select the proper parts when changing from one blade configuration to another. Refer to pages five
and six for part descriptions.
Changing from B to A-size blades:
1.)
Disconnect the power cord from Marlon 350.
2.)
Remove the top cover from the machine.
3.)
Remove the clamp stop shoulder bolts from each side
4.)
Remove the three 10-24 nylock nuts from each side.
5.)
The left clamp blade is now free and can be removed.
6.)
Remove the right anvil blade by lifting it straight up.
7.)
Remove the left forming blade by lifting it straight up.
8.)
Detach the right cutter blade from the drive pin. (The right cutter blade is now
free.)
9.)
Remove the two .126” B-size spacers from each side.
10.)
Remove the right forming blade by lifting it straight up. The right clamp
blade is now free.
11.)
Detach the left cutter blade from the drive pin, the arm drive screw must
be loosened to free cutter blade. (See step 8 for details.)
12.)
Leave the left anvil blade on, because it’s used in all three setups.
13.)
Reassemble the cutter blade assemblies in reverse order using the correct
color-coded parts.
14.)
Use the fifth .094” A-size spacer instead of .062spacer on the left hand
shoulder bolt.
