MGT 45M – 450M 1-1/2” SINGLE NXT2
INSTALLATION
8
MOUNTING WATER METER ASSEMBLY (IF UNIT IS NOT SKID MOUNTED)
1. Locate the meter. The meter may or many not have the cable attached. If not, locate the cable as well.
2. For a twin alternating system, the meter must be installed in the common outlet of the softeners. Refer to the Gen-
eral Arrangement drawing on page two (2). The water meter has a flow arrow stamped on it. The flow arrow on the
meter should be pointing away from the softeners.
3. After installing the meter, insert the meter end of the cable into the meter dome if necessary. Then run the meter
cable along the piping back to the unit 1 control valve.
4. Run the cable through a cable grip and into the back of the control and into the controller. Connect the meter cable
to the circuit board in the lower right as shown.
COMMUNICATION PORTS
FLOW METER CONNECTION
Summary of Contents for MGT 30M
