Doc No: SM-351 Iss A 18.07.16
Marlec Eng Co Ltd
Power Up to Default Screen
Start Monitoring
Press the WG and PV buttons on the 1200 Hybrid Controller.
Amps and Watts for each charge source are displayed. Any one of the following is also displayed:
CHG— Charging,
ON— Charge source is on but there is no voltage to start charging.
SBY– Standby, charge source is on but there is insufficient voltage to start charging.
Note: Any button press on the remote with the backlight off will switch it on and start it's countdown
timer (default 30s), further button presses when the backlight is on perform functions as shown below.
Using the Remote Display
Press the DOWN and UP buttons to scroll through the available screens;
WG (Amps) - PV (Amps) - Total (Amps) - Default Screen
The screen can be left to display on any screen, the default screen is recommended.
When the charge source, WG or PV, has been shutdown, either at the controller or via the Remote,
SWITCHED OFF is displayed.
Battery 2 is shown as
not connected.
Bulk Phase or Float
Phase is displayed
WG = Wind Generator
PV = Photovoltaic
panel
Battery symbols
change to show
approximate level
of charge 0%, 25%,
50%, 75% & 100%
Flashing empty battery Indicates low battery warning
Flashing full battery
Indicates regulating mode
WG or PV Switched OFF Coincides with Red illuminated
button on controller
WG or PV or
Total is dis-
played by
scrolling through
UP and DOWN
The scale and bar
graph alter in
response to the
levels of energy to
display
Accumulated
Ampere hours and
duration of
monitoring elapsed
3
