9
Procedure for Entering the Address
1. Connect the Control Unit, Keyboard, and
transformer. Do not turn the Control Unit on
yet.
2. Leave (!) the signal control module with
the home signal mast connected to it in its
original packaging. Connect only the brown
and the yellow wires from the signal control
module to the brown and red (!) terminal clips
on the Control Unit.
3. Set the Keyboard address to the desired
address. In our example (Keyboard No. 1) all
four coding switches at the „off“ position.
4. Turn on the 6021 Control Unit. Press the
„stop“ button.
5. Press the „go“ button. The home signal will
begin to switch between 2 signal aspects.
If the following step does not begin within
several seconds, the electronic circuit will end
the address setting process automatically.
6. Press the green button on button pair 13 of the
Keyboard until all of the LED‘s on the signal
light up. Only release the button at this point.
7.The main signal will begin to switch between 2
signal aspects.
8. Press the green button on button pair 14 of the
Keyboard until all of the LED‘s on the signal
light up. Only release the button at this point.
9. Turn the Control Unit off. The signal and the
signal control module can now be installed on
the layout.
Note:
• For long breaks during programming, the
signal terminates the programming mode
without a change. In this case, start from the
beginning again with the complete addressing
procedure. While addressing is taking place,
ensure that the breaks between the individual
keyboard commands are not too long.
• Once the programming has ended or has
been cancelled, the signal switches to dem-
onstration mode after a few seconds. In this
mode, various signal aspects of the respective
signal type are displayed.
• The control electronic circuit must be removed
from the packaging before testing the signal.
Summary of Contents for 76394
Page 1: ...76394 Ausfahrsignal...
