Fig. 2 Digital
Control Panel
DIGITAL CONTROL PANEL
NOTE:
USER PROGRAMING OF THE TIMER CYCLE IS EASILY ACCOMPLISHED
VIA A (12) BUTTON NUMERIC KEYPAD AND A (4) DIGIT NUMERIC LED
DISPLAY. CONTROL
START PROGRAMING:
FIRST:
Make sure doors are shut on both compartments.
SECOND:
Flip on POWER SWITCH, located in the middle of control panel
to the ON position.
THIRD:
Press the CLEAR button and HOLD for two (2) seconds. This
should clear the timer display to 00:00.
THE TIMER IS NOW READY FOR PROGRAMING. The timers are program-
mable from one second to 99 minutes and 99 seconds.
PLEASE NOTE:
TIMER WILL NOT START COUNTING DOWN UNLESS:
1)
DOOR IS SHUT.
2)
THE THERMOSTAT REACHES 193oF INSIDE THE
COMPARTMENT.
When the timer reaches “0” the word “END” will fl ash on the display. The
AUTO-ALARM will sound and continue until the START/STOP button is
pressed.
When you press STOP, the existing program remains in the system. It is nec-
essary to press CLEAR, then RE-PROGRAM the new time as needed.
NOTE:
To STOP the TIMER in MID-COUNT DOWN, PRESS and HOLD the
STOP button for a few seconds.
The word “PAUSE” will appear on the screen every time the door is opened.
When the door is closed, the timer will resume the count down.
FEATURES:
1)
FOUR DIGIT DISPLAY – Example 00:00
2)
AUTO ALERT = End of cycle sound.
3)
“END” = Displayed at the end of cycle.
4)
“PAUSE” = Displayed when doors are opened.
5)
START/STOP = Control Button for start and stopping.
6)
POWER SWITCH = Turn power ON and OFF.
NOTE:
Unit is equipped with MANUAL OVERRIDE in the event of a TIMER
FAILURE (CONSTANT STEAM).
SECTION 3. OPERATION
6A