
DIGITAL POWDER MEASURE INSTRUCTION MANUAL VERSION 1.1
5
6)
Connect the power cord from the trimmer to the control box and plug in the power cord from
the control box to an outlet.
7)
Move the power switch to On and set the motor speed to position 7-8.
8)
Run a lubed case through the trim die and then check the overall length of the trimmed case.
Loosen the lock ring against the trimmer and adjust the trimmer up or down in the die body if
needed to correct the case length. Again, verify that the cutter is not contacting the die body
and tighten the trimmer lock ring before trying another case.
9)
Once the case length is adjusted, the vacuum manifold should be installed around the die and
trimmer. Remove the two screws holding the manifold together and place the two manifold
sections around the die and trimmer. Reinstall the screws and tighten them securely. Attach
you shop vacuum hose to the manifold. The manifold is designed to fit 1 ½” hoses.
Figure 3. Vacuum Manifold Installation
Clasp vacuum manifold
over the windowed
section of the trim die.