DIGITAL POWDER MEASURE INSTRUCTION MANUAL VERSION 1.1
3
Set-up & Operation
1)
Install the trim die in your press.
Note:
for some short cases such as the 300 AAC, the trim die
lock ring may need to be installed on the underside of the die station rather than on top. An
offset toolhead may also be required. Cycle the press so that the shell plate or shell holder are
at their full travel and closest to the die station. Turn the die into the press until it contacts the
shell plate or shell holder, then back off the die about a ½ turn.
2)
Assemble the trimmer, by first installing the carbide cutter. Place the cutter inside the collet
approximately ½- ¾ of an inch and tighten using two wrenches. Install the nose cone with the
included 4 screws, do not overtighten.
Figure 1. Trimmer Assembly
