Precision Spotlight Instructions
2
Required for Installation:
• Four (4) No. 10 stainless steel pan head screws for spotlight bracket
(Length and type of screws to be determined by mounting surface)
• Two (2) No. 6 stainless steel pan head screws
(Length and type of screws to be determined by mounting surface)
• Two (2) #16 AWG butt wire connectors
!
WARNING
IF THE APPLICATION IS 24 VOLTS, THE 12 VOLT BULB WILL NEED TO BE
REPLACED WITH THE 24 VOLT BULB. TO REPLACE THE BULB REFER TO THE BULB
REPLACEMENT SECTION. (PAGE 5).
Failure to use the appropriate bulb wattage will damage the spotlight.
!
WARNING
BEFORE OPERATION REMOVE BLUE FILM FROM LENS. FAILURE TO
REMOVE FILM WILL DAMAGE THE SPOTLIGHT.
Mounting and wiring of the Precision Spotlight
1. Select a flat surface to mount the spotlight. Make sure there are no obstructions around
the spotlight that could interfere with the rotation (template included with light). Be sure
you will have wiring access to the underside of the chosen location and that drilling holes
will not damage existing wiring or structures. Avoid locations where lines, anchors and
sails might entangle or damage the light.
2. Refer to the template for mounting and wire hole location.
3. While installing the mounting bracket make sure that the securing screw is opposite the
direction that the light will be facing. Mark the mounting holes and center wire hole. Be
sure that there is at least a 6" (145 mm) radius of clearance from the center hole. See
dotted line on figure 1 (page 7).
4. Drill hole sizes appropriate for the type of screws or bolts being used. Note: the maximum
bracket hole sizes are No. 10 screws.
5. Drill the appropriate hole size to accommodate the wires. This will depend on the type of
wire being used.
6. The spotlight requires 12 or 24 volt power supplied through appropriate gauge wire.
(Note: If the wired bridge remote version is used, then 2 additional wires will need to
be routed from the remote to the spotlight.)
!
WARNING
CORRECT WIRE SIZE FOR THE RUN AND PROPER CIRCUIT PROTECTION
NEEDS TO BE SELECTED BASED ON ABYC STANDARDS. FAILURE TO FOLLOW
ABYC STANDARDS MIGHT LEAD TO SEVERE INJURY, DEATH OR DAMAGE
TO VESSEL.
7. Mount the mounting bracket after applying a small amount of non silicone sealant to the
area the screws or bolts penetrate the mounting surface. (Note: mounting bracket screw
heads should not protrude more than 0.2" (5 mm) above mounting bracket.)
8. Connect wires to spotlight using butt connectors. Red wire is positive, Black wire is
negative.
!
WARNING
POLARITY OF THE WIRES NEEDS TO BE CORRECT TO OPERATE THE
SPOTLIGHT! FAILURE TO WIRE CORRECTLY WILL DAMAGE THE SPOTLIGHT SYSTEM!
9. Slide spotlight over mounting bracket making sure the wires are not pinched and the
two holding tabs engage the light in the proper location. Align the securing screw hole
in the back of the spotlight base with the securing screw hole in the mounting bracket.
This will require a degree of pressure and effort as the mounting seal must be suitably
compressed during this process. For easier alignment, slightly lift the back side of the