DSM410
User’s Manual
Page 202
Revision 1.7.2
network must have the same values), and the last part defines the computer (i.e., every computer on
the network must have a different value). Where the value 255 appears in the subnet mask, the
values define the network and must be the same.
The most common value is 255.255.255.0.
If the “DHCP” parameter is set to “Yes”, you do not need to configure this parameter. If the “DHCP”
parameter is set to “No”, you will need to configure this parameter.
6.31.7
Default Gateway
This is the IP address of the router.
If the “DHCP” parameter is set to “Yes”, you do not need to
configure this parameter.
If the “DHCP” parameter is set to “No”, you will need to configure this
parameter.
6.31.8
Default DNS
This is the IP address of a computer on the Internet that can identify and locate computer systems
and resources on the internet. In most cases, this should not be required by the VDR100 and may be
left blank.
If the “DHCP” parameter is set to “No”, you will need to configure this parameter.
6.32 Maretron WSO100 Configuration
The DSM410 is capable of performing configuration of the WSO100 Wind/Weather Sensor. This
describes the configuration of the Maretron WSO100 firmware version 2.0.13. Figure 229 below
shows a screenshot of the WSO100 configuration menu.
Figure 229
– WSO100 Configuration Screen
6.32.1
Advanced Configuration
Advanced Configuration changes some complex parameters within the device, and should only be
performed by an advanced user. Typically advanced configuration is only done at installation and
should not need to be done while at sea.
