Versa Electronics
www.marcumtech.com
- 9 -
Press the
UP button to move to the next highest NOISE rejection level, or
press
DOWN to move to the next lowest NOISE rejection level. As you do
so, you should notice the indicator number change. After approximately
5-seconds, the
NOISE indicator bar will disappear and be replaced by the
normal operating depth display.
Other Showdown 5.6 Dual Beam Features
Backlight— Your Showdown 5.6 Dual Beam offers a warm “nightglow” back-
light that actually accentuates the pixels in the display. Can be turned on or
off by briefly pressing the
POWER button after unit is ON.
Neoprene Carry Bag— Protects your Showdown 5.6 Dual Beam during
storage, use and transport. Exterior Velcro flap seals out dust and moisture.
Interior Transducer Pocket— Small mesh pocket inside neoprene carrying
case. Always place your transducer in this pocket when not in use.
Adjustable Transducer Arm— Showdown 5.6 Dual Beam is equipped with
an extendable and adjustable transducer arm, which directs the transducer
over your ice fishing hole. Coupled with the round rubber transducer cable
stopper which fits over the top of the arm clip, this handy item keeps your
transducer level in the water at all times for optimal signal return. When not in
use, the arm folds up and fits snugly inside the neoprene-carrying bag.
Digital Depth— The digital depth display on the Showdown 5.6 Dual Beam
sonar provides a quick and easy way to determine depth. Digital Depth is
always displayed in the bottom-right of the view screen (unless NOISE or
SENS are being adjusted). In addition, digital depth scale indices show to the
left of the display area for quickly determining the depth of fish or your lure.
Simulator— To trigger the Showdown 5.6 Dual Beam Simulator mode, start
with unit turned
OFF. Press and hold the POWER button for approximately
5-seconds. You should see the “
SIMU” indicator bar appear at the top right of
the display. Simulator mode shows how bottom, a lure and fish might appear
on the unit if you were fishing in 32’ of water. It also allows you to adjust and
learn various sonar settings before you get out fishing. To turn Simulator mode
off, it is necessary to turn Showdown 5.6 Dual Beam Power
OFF by holding
down the
POWER button again.
Low Battery Warning— When battery power reaches very low levels,
a low battery indicator will appear and flash at the top right of the display.
An audible beep will also sound every 30 seconds. This signifies that it is
time to recharge the battery, or replace it with a fully charged spare.
WARNING: When you see and hear this warning, the Showdown 5.6 Dual
Beam may shut down within minutes.
“Last Settings” Memory— Your Showdown 5.6 Dual Beam automatically
remembers the settings you used last. So when it is turned
OFF and then
ON again, your previous settings will be preserved and active.
