17
ITA
17
ENG
Mounting using din sleeve
Remove the bracket if previously installed.
Install din sleeve into the opening in your dashboard, lip facing out.
Push out the top and bottom tabs to hold the sleeve firmly in place.
Before inserting this radio in the sleeve, wire the cable from the previously mounted antenna
and from the DC power leads. Red goes to a positive( + ) connection on your fuse block while
black connects to the vehicles chassis ground ( - ). Make sure all the connections are routed away
from any potentially pinching or slicing sheet metal.
Slowly slide the radio into the sleeve until it locks in place. When fitted the rubber ring will act as
a seal against din sleeve. At the left and right sides of the ring a slot space will be provided by
pulling slowly the left and right side of the ring. The slots in the fitted rubber ring will enable the
proper removal of radio from the din sleeve.
Removing the radio from din sleeve
If you plan to remove the radio from din sleeve, you should do it using the provided removal keys
as explained below.
Fully insert both removal keys straight into the slot spaces provided by rubber ring on the left and
the right edges of the radio dress panel.
You cannot remove the radio if only one key is available.
Press in fully and the radio will unlock from the sleeve making withdrawal from the sleeve possible.
Store the keys in a safe place for future use.
1�
�
3�
4�
5�
1�
�
3�
4�
