Marco MIX PB3, Service Manual

Page: 29 / 69

1000870,871,875,878,879,880,887 MIX Service Manual.b
Page 29 of 69
8.5 Dispense Solenoid or Pump replacement:
1. Remove Upper Fascia Panel as per section 8.4.
2. Undo 4 retaining screws as shown in picture below.
3. Then pull the plastic panel directly outwards from the machine. (For PB versions, push the
silicone dispense nozzle through the hole – the nozzle will need to be squeezed slightly).
To remove the dispense solenoid in a PB version: (C AUTION - make sure tank is drained fully first
as per section 8.3 !)
1. Disconnect all wires connected to solenoid.
2. Disconnect cold water feed in to the Silicone dispense nozzle by pulling upwards.
2. Pull dispense solenoid out of the silicone mounting grommet. If the grommet is damaged it may
need to be replaced.