Clock
Open the battery cover on the clock and insert 4x new AA batteries,
observing the correct “+” and “-“ polarity.
The unit can be placed onto any flat surface by using the built-in stand,
or placed onto any wall using the wall mount at the back of the unit. It is
recommended you place the clock near a window or in a location with good
reception as the automatic time setting requires a strong radio-wave signal.
Outdoor Remote Sensor
Open the battery cover on the sensor and insert 2x new AA batteries,
observing the correct “+” and “-“ polarity.
The outdoor remote sensor should be securely mounted to a wall using
the wall mount hole located at the back. There is also a pullout stand that
can be used to place the outdoor remote sensor on a flat surface. It is
recommended to place the unit in a dry, shaded area to protect it from
direct elements.
Low Battery Indication
The low battery icon will appear on the display indicating the batteries
should be replaced
Outdoor Temperature Synchronization
The remote sensor will automatically transmit the temperature to the clock
after the batteries are installed. The clock will also automatically search for
the signal from the remote sensor for a few minutes after the batteries are
installed. When the clock is searching for the remote sensor, the icon will
appear on the display of the clock.
If the outdoor temperature is not displayed after three minutes, hold the
OUTDOOR TEMP SYNC
button for three seconds to search for the signal again.
Getting started
