Losing Synchronization of the Outdoor Remote Sensor
If the clock had received the outdoor temperature successfully, but now
displays a blank value (--.-), the synchronization between the outdoor remote
sensor and the main unit may have been lost. Press and hold
OUTDOOR TEMP
SYNC
button on the clock for three seconds, the icon will appear and the
clock will attempt to search for the outdoor temperature for a few minutes to
re-initiate the synchronization with the remote sensor.
If the outdoor temperature is not displayed after three minutes, replace the
batteries in the outdoor remote sensor, bring the remote sensor closer to
the main unit and try the above steps again.
NOTE: The transmission range can be impacted by extreme cold
temperature, metallic or electronic objects, as well as obstructions and
interferences. You may need to experiment with various locations to get the
best results.
When the batteries are replaced in the outdoor remote sensor (or the reset
button of outdoor remote sensor is pressed), you will need to press and hold
OUTDOOR TEMP SYNC
button on the main unit for three seconds to re-initiate
the synchronization, otherwise the signal will not be recognized by the main
unit.
Daylight Savings Mode
•
Slide the
DST
switch to AUTO, when the RCC function is ON, and the
clock is in an area where the RC-WWVB signal can be received.
NOTE: the icon will appear on the LCD during daylight saving time.
•
Slide the
DST
switch to OFF to turn off Daylight savings mode
•
Slide the
DST
switch to ON, and the time will change to daylight saving
time automatically, whether the RCC function is ON or OFF.
Time Zone
Slide
TIME ZONE
switch to select the time zone, there are 8 time zone for
selectable:
Hawaii = HST
Alaskan = AKST
Pacific = PST
Mountain = MST
Central = CST
Eastern = EST
Atlantic = AST
NST = NST
EN
