4
BASIC
OPERA
TION
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTIONS
BASIC
CONNECTIONS
ENGLISH
REAR PANEL
r
REMOTE CONTROL IN and OUT
connectors
Using the supplied remote control connecting cord,
these connectors enable this unit to be connected to
a Marantz component equipped with remote control
connectors. These connections make it possible to
control an entire system that centers on the amplifi er
or other such component.
t
AC
INLET
Plug the supplied mains cord into this AC INLET and
then into the power outlet on the wall.
ST6003 can be powered by 230V AC only.
q
FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial
cable, or a cable network FM source.
w
AM antenna and ground terminals
Connect the supplied AM loop antenna. Use the
terminals marked “AM” and “GND”. The supplied AM
loop antenna will provide good AM reception in most
areas. Position the loop antenna until you hear the
best reception.
e
AUDIO OUT connectors
The audio signals are output from these connectors.
w
e
r
t
q
BASIC CONNECTIONS
CONNECTING THE AMPLIFIER
Use the audio connecting cord to connect the unit with a stereo amplifi er or AV amplifi er.
Cautions:
•
Do not connect the unit to the PHONO input connectors on the amplifier.
•
When making the connections, insert the plugs securely into the connectors. Failure to insert the plugs
securely may result in noise.
SPEAKER SYSTEMS
SPEAKER SYSTEMS
REMOTE
REMOTE
CONTROL
CONTROL
R
OUT
OUT
IN
IN
OUT
OUT
IN
IN
L
R
L
SYSTEM B
SYSTEM B
SYSTEM A
SYSTEM A
R
L
R
L
AC IN
AC IN
R
L
MODEL NO.
MODEL NO. PM5003
PM5003
PHONO
PHONO
TUNER
TUNER
CD
CD
AUX
AUX / DVD
DVD
IN
IN
OUT
OUT
RECORDER 2
RECORDER 2
(MD
MD / TAPE
TAPE)
RECORDER 1
RECORDER 1
(CD-R
CD-R)
PM5003N
PM5003N
MODEL NO.
MODEL NO. PM5003
PM5003
PHONO
PHONO
GND
GND
:
(Red)
(White)
Audio connecting cord (supplied)
(Red)
(White)
Signal fl ow
ST6003
Marantz Stereo Amplifi er
Notes:
• Do not plug in the mains cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Note that binding pin-plug cords together with mains cords or placing them near a power transformer will result in
generating hum or other noise.
