Marantz SR7011, Owner'S Manual

Page: 290 / 395

Symptom Cause / Solution Page
DTS Neural:X mode cannot
be selected.
0
DTS Neural:X cannot be selected when using the headphones.
－
Dolby Surround mode
cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
－
Sound modes other than
“Stereo” or “Direct” cannot
be selected.
0
Only “Stereo” or “Direct” can be selected for the sound mode if Headphone:X signals are input.
－
Audyssey MultEQ ® XT32,
Audyssey Dynamic EQ ® ,
Audyssey Dynamic
Volume
® and Audyssey
LFC™ cannot be selected.
0
These cannot be selected when you have not performed Audyssey ® Setup.
215
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
147
0
These cannot be selected when using the headphones.
－
“M-DAX” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
189
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 147
No audio is output from
PRE OUT or speakers for
ZONE2/ZONE3.
0
In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/
COAXIAL) are in 2ch PCM format.
－
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
format. To play back the audio in ZONE2 irrespective of the input signal format, set “HDMI Audio” in the
menu to “PCM”. Depending on the played back device, the audio may not be played back even with this
setting. In that case, set the audio format to “PCM (2ch)” on the played back device.
258
0
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 98.4 ft/30 m.
－
Contents Connections Playback Settings Tips Appendix
290
Front panel Display Rear panel Remote Index