60
4. Cooling fan confirmation
4.1 Fan failure sensor confirmation
1) Set to be SPK output 1W from the front channel.
2) Connect the 1pin (LOCK) of the connecter JN10 (on P754) to chassis (GND level) by a wire.
3) After 6 seconds the SPK relay works, and the SPK output isn’t output.
4.2 Temperature sensor confirmation
1) Connect a resistor (470ohm 1W) between JN10 3pin (T-2CH) and DC +12V.
2) Confirm the cooling fan starts working. (Status : JN09 between 1pin and 2pin = +7.5V, Fan speed = Low)
3) Remove the resistor.
4) Confirm the cooling fan stops.
5) Connect the resistor between JN10 4pin (T-3CH) and DC +12V.
6) Confirm the cooling fan starts working again.
7) Remove the resistor.
8) Confirm the cooling fan stops.
9) Connect the resistor between JN10 3pin (T-2CH) and DC +12V. And then connect another resistor between
JN10 4pin (T-3CH) and DC +12V.
10) Confirm the cooling fan starts working.
11) And then connect the resistor between JN10 2pin (SPEED) and DC +12V.
12) Confirm the cooling fan changes to work with high speed. (Status : JN09 between 1pin and 2pin = +11.5V,
Fan speed = High)
4.3 Fan catching a foreign body sensor confirmation
1) Connect the resistor (470ohm 1W) between JN10 3pin (T-3CH) and DC +12V.
2) Confirm the cooling fan starts working. (Status : JN09 between 1pin and 2pin=+7.5V, Fan speed = Low)
3) Set to be SPK output 1W from the front channel.
4) Hold the cooling fan by hand and stop it.
Notes: Take care of wound in the hand!
5) After 6 seconds the SPK relay works and the SPK output isn’t output.
C711
C713
C714
C712
CT13
CT11
CP12
CP14
CP11
CP13
R715
J713
R773
R743
R774
J714
R716
R744
R
T15
R
T43
RT73
JT13
RP44
RP74
RP16
JP04
RP43
RP73
RP15
JP03
P704
FL-CH
SR-CH
C-CH
P754
SL-CH
FR-CH
DC-OFFSET
IDLING
DC-OFFSET
IDLING
DC-OFFSET
IDLING
IDLING
DC-OFFSET
IDLING
DC-OFFSET
FA
N
FA
N
SIDE
SIDE
FRONT
TOP
WA300J102
WA300J101