Marantz PM-13S2 /FN/K1G, Service Manual

Page: 3 / 72

1
1. TECHNICAL SPECIFICATIONS
Power output (20 Hz – 20 kHz simultaneous drive of both
channels) .................
(8Ω load) 90 W x 2 [ N1B / U1B / FN ]
............................................................. 80 W x 2 [ K1G ]
........................... (4Ω load) 140 W x 2 [ N1B / U1B / FN ]
............................................................ 130 W x 2 [ K1G ]
Headphone rated output (When speaker rated output set
to 8 Ω load)
.................................... 120mW x 2 (32 Ω load)
Total harmonic distortion (20Hz – 20kHz simultaneous
drive of both channels, 8 Ω load) ............................. 0.05 %
Output band width (8Ω load, 0.05%) ............5 Hz ~ 40 kHz
Frequency response (CD, 1W, 8Ω load)
..................................................... 5 Hz ~ 100 kHz ±3 dB
Dumping factor (8Ω load, 20Hz – 20kHz) ..................... 100
Input sensitivity/Input impedance
PHONO (MC) ............................................ 270 µV/100 Ω
PHONO (MM) ............................................. 2.7 mV/47 kΩ
CD/LINE .................................................... 240 mV/20 kΩ
P.DIRECT IN ................................................. 1.7 V/20 kΩ
Output voltage/Output impedance
PRE OUT ..................................................... 1.7 V/220 Ω
Maximum allowed PHONO input (1kHz)
MC ......................................................................... 15 mV
MM ...................................................................... 150 mV
RIAA deviation (20Hz ~ 20kHz) .......................... ±0.5 dB
S/N (IHF-A, 1W, 8Ω load)
PHONO MC (0.5mV input) ..................................... 75 dB
PHONO MM (5mV input) ....................................... 86 dB
CD/LINE (500mV input) ......................................... 89 dB
Tone control
Bass (50Hz) ......................................................... ±10 dB
Treble (20kHz) ..................................................... ±10 dB
Power requirement
(U.S.A.) .................................................. AC 120 V 60 Hz
(Europe) ............................................ AC 230 V 50/60 Hz
(Japan) .............................................. AC 100 V 50/60 Hz
(China) ................................................... AC 220 V 50 Hz
Power consumption
(EN60065 7th Ed.) ................................................ 220 W
(UL60065) ............................................................. 220 W
(J60065) ................................................................ 220 W
127 (5)
109
(4-5/16)
440 (17-3/8)
444 (17-1/2)
400 (15-3/4)
19
(3/4)
25 (1
)
18
(3/4)
2. CAUTION
The layout of this amplifier is well concerned for sound
quality.
1. When screws and washers are removed, those parts
must be set to the same places.
2. When wires are removed, the wires must be installed in
the same roots, same places.
3. Do not hold the side panel (007D) to move the unit when
the unit is disassembled.
2.
注意
当機は音質を考慮したレイアウトになっています。
1.
ネジやワッシャ類を取り外した場合、元の位置に取り付けて
ください。
2.
ワイヤ類を取り外した場合の配線ルートは、元のルート通り
に戻してください。
3. 当 機を分 解した状 態で移 動するときは、サイドパネル
（ 007 D ）を持たないでください。