CAUTION IN SERVICING
Updating this unit
• When you replace the
IC101
, you need firmware updates. See "FIRMWARE UPDATE PROCEDURE".
• When you replace the WLAN MODULE, you need firmware updates. And MAC Address seal replacement is required.
See "FIRMWARE UPDATE PROCEDURE".
Initializing this unit (Initialization for the factory)
This unit initialization should be performed when the μcom, peripheral parts of μcom, and WLAN MODULE are replaced.
d
1. Press the power operation button "
X
" to turn off the power, and remove the AC plug from the socket.
2. While holding down buttons "
CURSOR
d
" and "
INPUT
" simultaneously, insert the AC plug into the wall outlet to
turn on the power. (Factory Reset)
3. Press the power operation button to place this unit on standby.
4. While holding down buttons "
CURSOR
f
" and "
8
" simultaneously, press the power button to turn on the power.
(Initialized)
5. Wait for more than 90 seconds after "
Initialized
" is displayed and then turn the power off.
(During this time, start and initialize the network devices.)
NOTE
: • If step 5 fails, start over from step 1.
• All user settings will be lost and the factory setting will be recovered after the set is initialized.
So make sure to note down your setting beforehand for restoring after the initialization.
Power operation
button(
X
)
Fast-revers/Reverse-skip
button (
8
)
CURSOR
d
11
Summary of Contents for NA6005
Page 8: ...Personal notes 8 ...
Page 30: ...Personal notes 30 ...
Page 39: ...BLOCK DIAGRAM 39 ...
Page 40: ...POWER DIAGRAM 40 ...
