Marantz MD110, Service Manual

Page: 6 / 30

2. Change of Playback Points (In continuous playback mode)
No. Key Display/Function
1 PL AY [CPLAY OUT]
2 Carry out No.4 and 5 in the above table
3 PL AY [CPLAY IN]
4 Carry out No.4 and 5 in the above table
5 ST OP [CPLAY MODE]
6 EJECT Disc out
5 Continuous Recording Mode
1. Continuous Recording Setting
No. Key Display/Function
1 MULTI JOG Select [CREC MODE]
2 Load the recordable disc
3 P LAY [CREC MID]
4 PLAY [CREC (zzzz)] CREC address
(0300h cluster = recording start point)
5 DIS PLAY [h****d@@@@] address
6 DISPLAY [c=xxxx a=yy] error
7 D ISPLAY [CREC (zzzz)]
8 S TOP [c=xxxx a=yy]
2. Change and End of Recording Points
No. Key Display/Function
1 Carry out No.1 to 3 in the above table Select [CREC MID]
2 MULTI JOG [CREC OUT]
3 PLAY [CREC (zzzz)] CREC address
(0700h cluster = recording start point)
Carry out No.5 to 8 in the above table
4 Carry out No.1 to 3 in the above table
5 PL AY Select [CREC MID]
6 MULTI JOG Select [CREC IN]
7 PLAY [CREC (zzzz)] CREC address
(0300h cluster = recording start point)
Carry out No.5 to 8 in the above table
8 EJ ECT Disc out
Starting address is the followings.
IN=30h cluster, MID=300h cluster, OUT=700h cluster
1. The recording start addresses of IN, MID, and OUT are described below.
IN 30H cluster
MID 300H cluster
OUT 700H cluster
2. An erasure prevention control is not detected in the test mode. Be careful not to enter the continuous recording
mode using a disc containing the data that should not be erased.
3. Do not record continuously for more than five minutes.
4. Take care that no vibration is applied during continuous recording.
Electrical adjustment
1 Precaution during confirmation of Laser Diode emission
During adjustment, do not view the emission of a laser diode from lust above for confirmation. This may damage
your eyes.
4