Manzano Laser Works deHavilland DHC-1 Chipmunk, Assembly Manual

Page: 18 / 26

26. 27.
This completes the wing structural assembly. The ailerons and flaps are installed after they and the wing are covered. Make sure the flaps still rotate down freely after the hinge points have been
glued. CA hinges are used for the ailerons.
After the ailerons and flaps have been installed, mount servos to the servo trays. Servo extenson leads will be necessary for the servos.
Route the servo leads through the servo lead tubes starting from the servo bays. Pull the connectors through the appropriate holes in the center section top sheeting.
Mount the servo trays using four wood screws in the corners of the trays.
28.
29.
Bend the landing gear legs using 1/8" diamater piano wire.
Place the landing gear legs into the slots of the landing gear
mounting blocks. Place a plywood retaining lug in the pockets of
the mount block. Mark the location of the retaining screws. After all
of the screw locations have been marked, dirll pilot holes for the
screws. Run screws into each hole.
Make up the four servo trays using the 1/32" plywood and 1/16"
balsa tray laminations. The flap and aileorn trays are different in
size so be sure to match the appropriate part pairs. Set the
laminations so there will be a right and left tray. The balsa
lamination faces the outside of the wing. The servo mounting lugs
are the same for all four trays.