Applied Measurements Limited
B24 Telemetry User Manual
87
product includes a certified module. The label should state the following (or similar wording that conveys the
same meaning):
The OEM must include the following statements on the exterior of the final product unless the product is too small
(e.g. less than 4 x 4 inches):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Contains FCC ID: S9NSPBTLERF
OR
This product contains FCC ID: S9NSPBTLERF
1. this device may not cause harmful interference,
and
2. this device must accept any interference received, including any interference that may cause undesired
operation.
FCC Product Manual Instructions
This section applies to OEM final products containing the B24 module, subject to FCC compliance. The final
product manual must contain the following statement (or a similar statement that conveys the same meaning):
Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. (Part. 15.21)
In the case where an OEM seeks Class B (residential) limits for the final product, the following statement must be
included in the final product manual:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In the case where an OEM seeks the lesser category of a Class A digital device for the final product, the following
statement must be included in the final product manual:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at his expense.
IC Labeling Instructions
When integrating the SPBTLE-RF into the final product, the OEM must ensure that the IC labeling requirements
are satisfied. A statement must be included on the exterior of the final product which indicates that the product
includes a certified module. The label should state the following (or similar wording that conveys the same
meaning):
The OEM must include the following statements on the exterior of the final product unless the product is too small
(e.g. less than 4 x 4 inches):
This device complies with RSS-210 of the IC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference,
and
2. this device must accept any interference received, including any interference that may cause undesired
operation.
Contains IC: 8976C-SPBTLERF
OR
This product contains IC: 8976C-SPBTLERF