User
’s Manual
EN
4
CAUTION:
CAUTION:
Do not over-tighten bolts-doing so many cause unnecessary damage to the wall.
Avoid excessive torque.
Concrete/Brick Installation
The concrete anchors must be used for concrete installation.
NOTE:
Begin by placing the wall plate into position against the wall, using the bubble level to keep it level.
Insert a concrete anchor into to rach hole
.
If necessary, a hammer can be used to liahtly tap each anchor into place so that they are flush with the
wall.
Once all of the anchors are in place ,move the wall plate back into position
.
1
2
3
4
Do not release the wall plate until it is properly mounted and secured to the wall.
Mark off four holes to be used for securing the mount and place the wall
Next,drill holes using an electric drill and 12mm masonry bit 50mm deepth.
5
6
7
Attach the bolt into the washer(G) that is placed in the wall
.
8
Do not tighten until all screws are in plate .
Step1: Wall plate installation
Wood Stud Installation
NOTE
least
16"apart.
and mark their locations with a pencil.
:For secure wood stud mounting,the wall plate must be mounted
to two studs at
Use a high-quality electrnic stud finder (commercially available) to locate two adjacent studs
1
Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots that are in
alignment with the studs.
2
3
With the help of an assistant, and using the bubble level to ensure the wall plate is level, position the wal
l plate against the wall in the desired mounting location.
4
You should mark four positions total.
5
Next, Pre-drill a 5mm hole 50mm deepth in the wall stud at each marked location.
6
please position the wall plate against the wall and line up the mounting slots with drilled holes
7
For each location, insert a lag bolt and washer(J) into the wall
8
Tighten bolt with an open ended socket wrench by turning clockwise until tight.
Hardware kit:
A
B
C
(×4) M5×16 Screw
(×4) M6×16 Screw
(×4) M8×16 Screw
D
E
F
G
(×4) M8/M6/M5 Washer
(×
6
) M8 Bolt
(×6) M8 Concrete anchor
(×6) M8 Washer