Manta DWF451L, Maual Manual, Page: 30 / 48

30
EN
1.
To open the dispenser, turn the cap to
the “open” (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, be
careful not to overfill.
3. Replace the cap by inserting it aligned with
“open” arrow and turning it to the “closed”
(right) Arrow.
The rinse aid is released during the final rinse
to prevent water from forming droplets on
your dishes that can leave spots and streaks.
It also improves drying by allowing water to
sheet off the dishes.
Your dishwashers are designed to use liquid
rinse aids. The rinse aid dispenser is located in-
side the door next to the detergent dispenser.
To fill the dispenser, open the cap and pour
the rinse aid into the dispenser until the level
indicator turns completely black. The volume
of the rinse aid container is about 140 ml.
Be careful not to overfill the dispenser, because
this could cause over sudsing. Wipe away any
spills with a damp cloth. Don‘t forget to replace
the cap before you close dishwasher door.
Attention!
Clean up any rinse aid split during filling with
an absorbent cloth to avoid excess foaming
during the next wash.
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four or six settings.
Always start with the dispenser set on “4” If
spots and poor drying are problems, increase
the amount of rinse aid dispensed by removing
the dispenser lid and rotating the dial to “5”.
If the dishes still are not drying properly or
are spotted, adjust the dial to the next higher
number until your dishes are spot-free. The
dose is factory set in the position 5.
Rinse-Aid indicator
Rinse aid dispenser