Install one end of your hose assembly
onto the hose adapter and slide the
clamp as far up onto the hose adapter
as possible. The clamp should go up
to the hose adapter. Tighten with a
straight head screw driver.
Install the opposite end of the hose assembly to the hose adapter located
on the bottom of the pail. Again, make sure the clamp is moved all the
way up to the hose adapter.
The easiest way to install the male adapters is with a 9/16” deep socket. If you
don’t have one available, use an adjustable wrench. Tighten them until they
stop turning. Note: you will still see some threads between the adapter and the
ball valve. This is normal.
Next you will assemble the pole to hold the bucket. It
comes in 2 pieces that need to be joined. The fitting
is already installed on one end. Just slide the hooked
end into the fitting and tighten with the flat head
screwdriver.
Once the arm pieces are joined, slide the
bottom of the arm onto the table bracket. If
there is a screw through the end of the arm,
align the screw with the slot in the bracket.
Once you have installed the bracket onto the
table or counter you will be using, you can
adjust the direction of the pail using the upper
connection from the previous step. Simply
loosen the screw and reposition the arm to the
desired direction and retighten.
Attach the bracket to your work surface and
tighten well.
table or counter here
tighten here