TRI-LOCK OPERATION AND MAINTENANCE
TRI-DIM
13
Start-Up Procedure
(Continued)
14.
Place new filter in a new PVC bag. Note- only the frame of the
filter should be touched. Locate the new bag’s shock cord
around the bag out port on the inside rib (where the previous
bag was located). Make sure the stub from the previous bag is
within the new bag.
15.
Tighten safety strap on the new bag until it is immobilized and
cannot move. (See Figure 10)
16.
Pull old bag and stub into the new PVC bag and away from the
new filter.
17.
Slide Filter(s) into housing and engage locking mechanism to
seal off filter(s) on knife edge(s).
18.
Close swing bar and latch for a gel seal filter or screw down
drive bolts clockwise on a gasket seal filter.
19.
Cinch bag as so it is taut across the surface of the sealing lip.
Caution: do not cinch bag so tight as to cause the shock cord
to slip off of the sealing lip. (See Figure 13)
20.
Roll bag up-replace the door and tighten all door latches.
Fig. 20