*#03#10#
03—command, 10—amount, Max 16, Min 1, default setting is 10.
5) Setting Local Area Code
*#04#*0755#
10—command, *0755—area code, Max 5 numbers, use “*” instead if area code is less than 5
digits.
6) Setting IP numbers
*#05#17911#
05—command, 17911—IP numbers, Max 5 numbers, use “*” instead if IP number is less than 5
digits.
7) Hide Caller ID (being sent out) Setting
*#13#01#
13—command, 01—value, Max-02, Min-00, Default setting is 00
· 00 - presentation indicator is used according to the subscription of the CLIR service.
· 01 - CLIR allowed
· 02 – CLIR prohibited
Notice: This setting needs carrier support.
8) Bar Incoming Call Setting
*#14#00#
14—command, 00—value, 00—no barring, 01—set barring, 00—default setting
9) FSK setting (optional) (should confirm before order)
*#17#00# setting caller ID
17-order, 00-value, 00-DTMF, 01-FSK, default setting is 00
This setting needs terminal has FSK chip set support
10) Billing Mode Setting
*#15#00#
15—command, 00—value, 01—reversal polarity, 02-12 KHz, 03-16 KHz, 00—default setting
11) IMEI Change Setting (for Quad Band M10 Module only)
1. Write IMEI to RAM
*#18#IMEI no.#, 18—command, IMEI No. –15-digit IMEI no.
2. Check IMEI, if it is right then write it to module
*#19#IMEI no.#, 19—command, IMEI No. –15-digits IMEI No.
Notice: Step 1 and Step 2, IMEI no. must be the same
12) Pin Lock and Network Lock Setting (optional)(Should confirm before order)
PIN LOCK
1. Set to open PIN code check and automatic PIN lock function
*#07#*1234# 07-command, 1234- The current SIM card PIN code
If set successfully, the device will open PIN code check, and automatically change the current
SIM card into “PIN on” from “PIN off”
2. Set to Close PIN code check and automatic PIN lock function
*#08#*1234# 08-command, 1234- the current SIM card PIN code
If set successfully, the device will open PIN code check, and automatically change the current
SIM card into “PIN on” from “PIN off”
3. Set to change PIN code, open automatic PIN lock function
