Manitowoc Q210 series, Technician'S Handbook

Page: 196 / 236

196 Part Number 80-01111-9 7/10
Q270 Condenser Fan Motor Replacement
Access to remove, clean or replace the condenser fan/
motor can be obtained by performing the following:
1. Disconnect electrical power to the ice machine at
the electrical service disconnect.
2. Remove the screws that secure the condenser to
the cabinet and the base to the cabinet.
3. Slide the base forward until contact is made with
the stop screw (approximately 2.5" [6.3 cm]).
4. Remove right hand screw securing condenser to
base.
5. Pivot condenser forward to obtain 5" (12.7 cm)
between the cabinet and condenser shroud. Take
care not to kink refrigeration tubing.
Accessing the Condenser Fan Motor
!
Caution
Do not move base p ast the st op scre w, t ubing
damage could result.
REMOVE THREE
SCREWS AND
PULL BASE
FORWARD TO
STOP SCREW.
2.5" (6.3 CM) TO
STOP SCREW
REMOVE SCREW AND
PIVOT CONDENSER TO
OBTAIN 5" (12.7 CM)
CLEARANCE BETWEEN
CABINET AND
CONDENSER SHROUD.
5" (12.7 CM)
CLEARANCE
AFTER
PIVOTING
CONDENSER
PT1295A