Installation
Section 2
2-2
Uncrating
WARNING
Never attempt to tilt the cabinet alone. Always use
two or more people when tilting the cabinet to
remove the shipping skid or to move it through
doorways.
1.
Remove the bottom shipping skid using one of
the methods below:
•
Lay the cabinet on its back, elevated and
supported by wooden blocks. Remove the
skid mounting bolts and separate the skid
from the cabinet.
•
Tilt the cabinet from side to side and remove
the mounting bolts. Support the weight of the
cabinet apart from the skid.
2.
Install the legs or casters and torque them to 360
inch-pounds. Refer to the drawing at right.
3.
Return the cabinet to the upright position.
4.
Remove any remaining crating materials.
CAUTION
If the cabinet was placed on its back while moving
it or while removing the bottom shipping skid, wait
at least two hours after returning the cabinet to the
upright position before starting the refrigeration
system.
CAUTION
Never use sharp instruments to cut the plastic or
cardboard crating materials. Damage to the cabinet
exterior may result.
Installing Cabinet Legs
SV1342
THREAD LEVELING
LEG INTO BASE OF
CABINET
THREAD FOOT IN
AS FAR AS
POSSIBLE
