Manitowoc F Series, Installation, Use & Care Manual

Page: 11 / 36

Part Number: 000006528 12/15 11
Cleaning and Sanitizing Interior Bin
Interior of bin must be cleaned and sanitized prior to use
and must be cleaned on a routine basis during use.
Single door upright ice storage bins are equipped with
polyethylene liner walls and stainless steel bottoms which
must be cleaned and sanitized every six months with
Manitowoc Ice Machine Cleaner and Sanitizer.
,
Caution
Use only Manitowoc approved Ice Machine Cleaner
and Sanitizer for this application (Manitowoc Cleaner
part number 94-0546-3 and Manitowoc Sanitizer part
number 94-0565-3). It is a violation of Federal law to
use these solutions in a manner inconsistent with their
labeling. Read and understand all labels printed on
bottles before use.
n
Warning
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or Sanitizer.
1. Remove upper inspection windows by sliding windows
to one side. Grasp the end of the front window and pull
toward you as the window is slid to the opposite side.
Repeat for rear window.
REAR WINDOW
FRONT WINDOW
2. Mix a solution of cleaner and warm water. Depending
upon the amount of mineral buildup, a larger quantity
of solution may be required. Use the ratio in the table
below to mix enough solution to thoroughly clean all
parts.
Solution Type Water Mixed With
Cleaner 1 gal. (4 L) 16 oz. (500 ml)
cleaner
3. Wash bin walls, hopper, access door plate and rinse all
areas thoroughly with clean water.
IIportant
Do not rinse after sanitizing.
4. Mix a solution of sanitizer and warm water.
Solution Type Water Mixed With
Sanitizer 3 gal. (11 L) 2 oz. (60 ml)
sanitizer
5. Sanitize bin walls, hopper and access door plate. Use a
spray bottle to liberally apply the solution. Do not rinse
the sanitized areas.
Cleaning Exterior Bin
Exterior stainless steel surfaces can be cleaned with a
stainless steel cleaner and polish.
Section 4
Maintenance