Manitowoc EC Serie, Installation Use And Care Manual

Page: 24 / 33

4-5
Section 4 Maintenance
REMOVAL OF PARTS FOR
CLEANING/SANITIZING
1. Disconnect power to the ice machine at the
electric switch box.
2. Turn off the water supply to the ice machine at
the water service valve.
WARNING
Disconnect electric power to the ice machine at the
electric switch box before proceeding.
3. Remove the parts or components you want to
clean or sanitize. See the following pages for
removal procedures for these parts.
WARNING
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or
Sanitizer.
4. Soak the removed part(s) in a properly mixed
solution.
Solution Type Water Mixed With
Cleaner 4 l 500 ml cleaner
Sanitizer 15 l 30 ml sanitizer
5. Use a soft-bristle brush or sponge (NOT a wire
brush) to carefully clean the parts.
CAUTION
Do not mix Cleaner and Sanitizer solutions
together. It is a violation of Federal law to use these
solutions in a manner inconsistent with their
labeling.
CAUTION
Do not immerse the water pump motor in the
cleaning or sanitizing solution.
6. Use the solution and a brush to clean the top,
sides, and bottom evaporator extrusions; the
inside of the ice machine panels; and the entire
inside of the bin.
7. Thoroughly rinse all of the parts and surfaces
with clean water.
8. Install the removed parts.
9. Turn on the water and electrical supply.
BIN DOOR REMOVAL
1. Disconnect the electric power to the ice machine
and remove ice from bin.
2. Grasp the rear of the bin door and pull bin door
forward approximately 12.7 cm.
3. Slide bin door to the rear while applying upward
pressure (The rear door pins will ride up into the
track slot and slide backward to the stop tab).
4. While applying pressure against the bin door pull
down on the rear of each bin door track until the
door pins clear the stop tabs.
5. Slide the rear door pins off the end and then
below the door track. Slide bin door forward
allowing the back of the door to lower into the
bin. Continue forward with the bin door until the
front pins bottom out in the track.
6. Lift right side of door until the front pins clear the
track.
7. Remove door from bin.
PRESS DOWN
TO RELEASE
DOOR
STOP TAB
TRACK
SLOT
SLIDE
DOOR
FORWARD