Mounting a Drive in the Drive Case
These steps are for installing a 3.5-inch
drive device in the drive case.
NOTE:
A special adapter kit is required
in order to install a 2.5-inch drive.
1. Remove the drive case
cover by sliding it
toward the back of
the unit.
2. If you plan to install a drive that features removable media, carefully
punch out the center part of the front panel.
IMPORTANT:
If you are installing a new hard drive in the case, you
may need to configure the drive before you
install it. Refer to the drive manufacturer’s
documentation and configure the
drive as Master, Cable Select
or Slave depending on the
configuration of your
computer. After you
complete this
installation, you
may also need to
re-configure the
computer’s BIOS
setup to make the
drive functional in the system.
SATA Connector
Power Connector
Diagrams are representational
of the entire line of MANHATTAN
docking kits and may not depict
specific cables/connectors.
