mangOH Yellow, Hardware Architecture Manual

Page: 34 / 41

mangOH Yellow Hardware Architecture Guide
Rev 2 Oct.19 34 41113116
2.6 IoT Connector Interfaces
The mangOH Yellow provides one IoT Connector (CN601), which supports the signals defined in the Project
mangOH IoT Expansion Card Design Specification, as detailed in
Table 2-2 on page 16 .
The default configuration (enabled signals) for the IoT Connector is shown in Figure 2-25 .
The IoT Connector interface configuration can be modified as detailed in Table 2-9 .
Figure 2-25: IoT Connector Configuration
Table 2-9: IoT Connector Interface Configuration Changes
Change type Change effect Method Change duration
Software Enable/disable identified signal(s) on
a specific IoT Connector.
API command Modifies running configuration until device
reboots or another change is made.
CF3 IoT Connector #0
(CN601)
UART
PCM
SPI
SDIO
USB
I2C
ADC0
PPS
GPIO_1
N_RESET
CARD_DETECT_IOT0
UART1
PCM
SPI1
SDIO
HSIC
N_RESET
I2C1
GPIO42
ADC0
GPIO40
DR_SYNC
GPIO_2 SPI1_SRDY
GPIO_3 GPIO7
GPIO_4
GPIO8
GPIO36
RESET_N
ADC3
Note: Default configuration — Solid lines
Alternate configuration — Dashed lines