6
Installation and Use
Before fitting the Bathing Cushion in the
bath
•
Remove any non slip mats from the area
where the suction cups will be positioned.
•
Ensure the bottom of the bath is clean
and smooth, with no oil or bath cleaner
residues that will prevent the suction feet
from sticking.
WARNING:
The suction cups
may not adhere to the surface in baths
that have been re-enamelled or that have
rippled or textured surfaces. Do not use if
the suction cups do not adhere to the bath.
•
Pass the air hose through the loop in
the
corner of the backrest (
A
fig.1), on the
side that you propose getting into and out
of the bath. The air inlet valve (
B
) can be
rotated, allowing the hose to be led to the
appropriate corner.
Fitting the Bathing Cushion in the bath
•
Fold the backrest over onto the seat
as
indicated in fig. 2. Lightly place the deflated
Bathing Cushion in the middle of the empty
bath with the ‘handle’ (
C
) aligned with the
centre of the bath.
•
Hold the ‘handle’ and pull the Bathing
Cushion towards the slope of the bath
until there is a gap of approximately 25mm
between the bath slope and ‘handle’
(
C
figs. 2 & 3).
•
Firmly press all four suction cups down
and check that they are securely stuck to
the bath. Wet them to help them stick if
necessary.
•
Fold the backrest out so that it rests on
the
slope of the bath.
A
B
25mm approx.
C
C
2
1
3
