leglifter
Standard fitting instructions
Fit the looped end of each strap around the
legs, castors or bed frame on the opposite side
of the bed (
A
fig. 1) and pass the straps under
the mattress.
Fit the hook of each strap onto the Leglifter
flap (
B
fig.1) and position the Leglifter loosely
alongside the bed, clear of any obstacles such
as a bedside table.
Tighten the straps to pull the edge of the flap
(‘Vee’ of deflated Leglifter) under the mattress
by approximately 1 to 2 fingers width (
C
fig.2).
Connect the Leglifter air hose and hand control
(
D
fig.3) to the Airflo
as indicated in the separate
Airflo compressor user instructions.
Test that the Leglifter inflates to fully vertical
against the mattress and further tighten the
straps if necessary.
NOTE:
Upon final adjustment, the edge of the
flap settles to sit on the frame/divan (under the
mattress) by about 1 to 2 fingers width. This will
vary according to bed type e.g. divan, sprung
divan, narrow framed bed.
Place the Airflo compressor by the side or
under the bed in an out of the way position.
•
•
•
•
•
•
3
freedom through lightweight solutions
MI0003 issue 5
2
3
1
A
B
D
1 to 2 fingers
width
‘Vee’
C
