6
Fixed mode zoom
Rotate the knob right (or left, dependent on the zoom direction) to zoom tele. Zoom speed is always constant, limited to the pre-set speed indicated by LED.
Rotate the knob left (or right, dependent on the zoom direction) to zoom wide. Zoom speed is always constant, limited to the pre-set speed indicated by LED.
Customizing zoom direction
To change the zoom direction keep pressed simultaneously “focus far” and “focus close” buttons until the LED indicator will light off.
The buttons must be kept pressed for at least 3 seconds.
The new zoom direction information will be permanently stored in the controller's internal flash memory and restored after each power off.
Standby mode
Press the button once to switch camera into standby mode.
While camera in standby mode press the button again to switch camera back into normal operation mode.
Pressing this button while camera is switched off will have no effect on camera operation.
Focus close
Keep the button pressed to adjust the focus for close objects.
Works only if camera in manual focus mode.
Focus far
Keep the button pressed to adjust the focus for far objects. Works only if camera in manual focus mode.
Record start/stop
Press the button once to start recording.
Press the button again to stop recording.
The LED indicator will blink when that the camera is recording.
Zoom direction reprogramming may be done practically unlimited number of times (min. 100.000, times).
Push Auto Focus
Press the button to put the camera temporarily into Auto Focus mode.
As soon as you release the button the camera returns into manual focus mode.
This button has no effect, if camera is already working in Auto Focus mode.
PUSH
AF
