dmc3-4
2861 Congressman Lane | Dallas, Texas 75220 | 800.877.6631 |
www.mssystems.com
Page
19
MC960 Power Amp Installation
Run the MS7XSC cable
from the dmc1H or
dmc1HC wall housing to
the remote power
amplifier.
Run the MS3XSC cable from the
remote amplifier to
each volume
control (use the SVC96 for stereo or the MVC1 for mono).
From each volume control, run the MS2SXSC to each
respective speaker as shown in Figure 17.
The remote power amplifier should be located in a closet or
utility closet and should be located within 6 feet of a
standard NEMA 5-15R 120VAC receptacle. Install a 1-gang
and a 2-gang box
at the location for
the remote
amplifier on a
stud. Allocate the 1-gang and 2-
gang boxes relative to one another
as shown in Figure 18. Run all
MS3XSC cables from the volume
controls to the remote amplifier’s
2-gang box.
Run the MS7XSC cable from the
dmc3-4 to the remote amplifier’s 1-gang
box. The remote amplifier is designed to
mount over the 1-gang and 2-gang boxes on a single stud. Note: The
speaker cables CANNOT be located in the same gang box used for
120VAC wiring.
Each pair of stereo or mono music speakers is controlled by a single
volume control. The volume controls install in a standard single gang box.
Run a MS3XSC cable from each volume control location to the remote
Figure 17 - Power amp wiring
Figure 18 - Power
amp installation
DMC1H
MS3XSC
Figure 19 - Speaker installation
MS7XSC
MS3XSC
MC960PA
