M&K Sound IW150, Operation Manuals

Page: 6 / 12

6
B A C K B O X I N - W A L L L O U D S P E A K E R S
5. Connect the speaker to cables in the wall, and place
cabinet into “the wall cut”. 6. When speaker is placed into “the waa cut”, turn
the Torx screws on the front clockwise to activate the
mounting clamps.
7. Check if speaker is perfectly aligned 8. Mount and align the grille,
- and your installation is done!
Important Practical Information!
When using an electric tool for screw mounting, adjust the tension function to prevent the dog screws from
being over-tightened. It is also recommended to use moderate or low speed when tightening the dog screws.
If removal of speaker is needed for service, make sure to loosen the front dog screws slowly until you can feel
some resistance.
At this point, the mounting clamps should be turned back to neutral position and speakers are ready to be pulled
out of the wall cut.
Mounting
clamps