M&H RWT35.50, Operating Instructions Manual

Page: 23 / 64

8
Radio-wave Tool Setter RWT35.50
Aligning the Stylus
Steps:
ƒ
Loosen the clamping screws and turn the adjustment bolts until they reach their limit in the upper position.
ƒ Tighten the clamping screws so until the adjustment bolts can just be turned with moderate-force.
ƒ Blow the adjustment bolts and the V-Slots clean.
ƒ Place the Tool Setter in the V-Slots.
ƒ
Check the parallelism of the stylus in the X Axis using an dial gauge.
ƒ Adjust the Tool Setter in the Y Axis to < 5µm by turning the adjustment bolts.
ƒ Tighten (2x) the adjustment bolts.
ƒ Using the third adjustment bolt, adjust the tool setter around the X-Axis to < 5µm
ƒ Tighten the third adjustment bolt
ƒ Take the Tool Setter out of the machine and securely tighten all 3 clamping screws
by hand (ca.10Nm).
ƒ Blow off the adjustment bolts and the V-Slots.
ƒ
Put the tool setter back in the V-Slots and verify the alignment.
ƒ Calibrate the Tool Setter!
Dial gauge
#3079
Hexagon Key
AF3mm #1780
Clamping screws
AF3mm #5114
Adjustment bolts
AF3mm #4277
X-Axis
Y-Axis