Rolling Code Transmitters - Series "100"
Rolling Code Transmitters - Series "100"
Specifications and Programming Instructions
Specifications and Programming Instructions
➢
Commercial Sequence or SBC Programming (Optional)
Modes
Functions
Programming (on operator's ECB)
Commercial
Sequence -
1-Button
OPEN / CLOSE → Button
Door is CLOSED:
- Click Button → Door OPENS FULLY
During UPWARD Travel:
- Click Button → Nothing happens
Door is OPENED:
- Click Button → Door CLOSES FULLY
During DOWNWARD Travel:
- Click Button → Door reverses and OPENS FULLY
Door is STOPPED:
- Not possible in this mode. Door is either FULLY
OPENED or FULLY CLOSED.
Standard default mode.
1.Door is in fully CLOSED position.
2.On ECB, verify if the close limit
switch is activated (CLOSE LED is
ON).
3.On ECB, set selector switch on
9 = SBC
.
4.On ECB, press “
STOP
” button.
5.On ECB, select run mode
(1, 4, or 5)
.
Single Button
Control (SBC)
Available with the
Electronic Control
Board (ECB) only.
Alternating
Sequence
OPEN / STOP / CLOSE → Button
Door is CLOSED:
- Click Button → Door OPENS
During UPWARD Travel:
- Click Button → Door STOPS
Door is STOPPED:
- Click Button → Door CLOSES
During DOWNWARD Travel:
- Click Button → Door STOPS
Door is STOPPED:
- Click Button → Door OPENS
Note
: If the door is STOPPED for more than 2 minutes,
the next movement will be UPWARD regardless of the
previous movement.
1.Door is in fully CLOSED position.
2.On ECB, verify if the close limit
switch is activated (CLOSE LED is
ON).
3.On ECB, set selector switch on
9 = SBC
.
4.On ECB, press “
OPEN
” button.
5.On ECB, select run mode
(1, 4, or 5)
.
FCC and ISED
This device complies with Part 15 of the FCC Rules and Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE:
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and
Industry Canada ICES standards. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate
the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help.
For further information, please consult the operator's Installation & Instruction Manual or contact our Technical
Support Department at
1-800-361-2260
.
1-800-361-2260
4
TN1054 REV 2 - 2022/01/24
