Rolling Code Transmitters - Series "100"
Rolling Code Transmitters - Series "100"
Specifications and Programming Instructions
Specifications and Programming Instructions
➢
Transmitter Programming: RADIOEM144
The RADIOEM144 Rolling Code Transmitter can be used to control up to 144 doors with Open / Close / Stop function.
Two rotary dials (Letters: A to L) and (Numbers: 1 to 12) permit for a proper door selection. The Transmitter can be re-
programmed as needs change. Replacement Battery: 2x AA (1.5V).
Transmitter
Modes and Functions
Transmitter Programming
RADIOEM144
Multiple Door (up to144 doors)
3-Button Transmitter
1.OPEN → Top Button
2.CLOSE → Middle Button
3.STOP → Bottom Button
No initial programming is required.
This Transmitter is ready to be matched to the
Receiver of your choice, refer to section Transmitter
to Operator Matching (Pairing), p. 3.
➢
Transmitter to Operator Matching (Pairing)
The On-Board Radio Receiver
RADIORE101
, featuring Rolling Code Technology, is factory installed on all operators
equipped with an Electronic Control Board
BOARD 070
since November 2013.
The Series 100 Transmitters are compatible with the
RADIORE101
Receiver, as well as the on-site installation kits
RADIOKIT004/005
(operators prior to November 2013) and the External Radio Receivers
RADIORE901/901A/901B
.
The Series 100 Transmitters are also compatible with
RADIORE102
,
except for RADIOEM103SD and RADIOEM144.
Compatible Receivers
RADIORE101 (ECB BOAR070) /
RADIOKIT004
(RADIOKIT005)
(On-site Installation Kits)
RADIORE901/901A
(RADIORE900/900A)
RADIORE901B
(RADIORE900B)
RADIORE102
(not compatible with
RADIOEM103SD and
RADIOEM144)
1-800-361-2260
2
TN1054 REV 2 - 2022/01/24
