1. Turn the Main Booster Power Switch to ON position. The LED indicator located in the front panel
will illuminate BLUE indicating power is available in the Boost 200 system.
2. Remove the 12 Volt DC protective cover or covers.
3. Insert the device 12 Volt accessory plug that can be powered by the Power Supply into the 12 Volt
power port of Boost 200.
4. Turn on the power of the 12 Volt DC device being powered by the Boost 200 unit.
5. Turn the Main Booster Power Switch to OFF position when the system is not in use.
200 WATT AC INVERTER OPERATING INSTRUCTIONS:
SYSTEM NORMAL OPERATION ————————- GREEN LED
OVERLOAD ——————————————————— RED LED
LOW BATTERY OR LOW INPUT POWER ———— RED LED
1. Turn the Main Booster Power Switch to ON position. The LED indicator located in the front panel will
illuminate BLUE indicating power is available in the Boost 200 system.
2. Prior to connecting the device to be powered to the inverter, make sure the inverter power switch is
in OFF position.
3. Prior to plug in the device, make sure the device power switch is OFF and ensure the current drawn
by this device is not to exceed 1.81A or 200W maximum power consumption.
4.
Remove the plastic protective cover from the inverter receptacle.
5. Connect the device 110 Volt AC electrical plug into the inverter receptacle.
6. Turn on the inverter power switch to “II” position. If the inverter is operating properly, the green LED
indicator will illuminate. Now turn ON the device. If the green indicator remains on, the system is
operating properly. If the inverter green LED light turns OFF, turn off the device then turn the power
switch to “O” position to turn OFF the inverter immediately. See the trouble shooting guide. The
inverter may have been over loaded or the input voltage may be too low.
Note: Power is provided for both the inverter & USB outlet when the inverter switch to ON position.
CAUTION:
Some rechargeable devices are equipped with a separate charger, which can be connected into this
inverter AC receptacle. However certain rechargeable devices are manufactured with built-in chargers
(see device owner’s manual). This category of devices may cause internal damage to inverters and
should not be used with this inverter. The temperature of the device must be monitored for the first 15
minutes of operation. Abnormally elevated temperature of the device is an indication that they should not
be used with this inverter.
110 Volt AC Household Electronic Devices
Powered by Boost 200 built-in 200 Watt inverter
Electronics Device Power Consumption Approximate Operating time
Small Utility light 2 Watt 45 Hours
iPhone/iPod/MP3 4 Watt 22 Hours
Radios 8 Watt 10 Hours and 30 Minutes
Fans 20 Watt 4 Hours and 30 Minutes
Power tool chargers 25 Watt 3 Hours and 40 Minutes
Up to 10Volt
Digital/Video Camera 30 Watt 3 Hours
Cell phone Chargers 35 Watt 2 Hours and 45 Minutes
9” portable TV 50 Watt 1 Hours and 50 Minutes
IMPORTANT NOTE:
The above listing is prepared for reference purposes ONLY. Certain electronic de-
vices exceed the power consumption wattage listed. Prior to powering the intended electronic devices,
refer to and review the Instruction Manual for actual wattage requirement.
Model No. 2032
S
he
et
5
of
9
