IMPORTANT ADVISORY NOTES
Do not use with dry cell batteries. These batteries may burst and cause injury to person or damage
personal property.
Do not attempt to face the battery being jumped. Stay away as far as possible from the battery when
making the final connection.
DO NOT CONNECT TO or jump start a 6 or 24 Volt battery.
If battery acid comes in contact with skin or eyes, rinse immediately with water for 20 minutes. Seek
medical attention if redness, irritation or pain is present.
DO NOT smoke, use matches, lighters or an open flame near batteries.
This products contains chemical substances including lead. Wash hands thoroughly after handling
Lead Acid Batteries.
Never allow red (Positive) and black (Negative) clamps to come in contact with each other or
contact with metal object at the same time.
To protect against electrical hazards, do not immerse charger, adapters, or unit in water or other
liquid.
Close supervision is necessary when working near children.
Do not use unit for applications other than its intended use.
Always connect the red (+) clamp to the positive battery terminal first. Connect black (-) clamp to the
negative battery terminal as final connection.
Jumpstart vehicles in a well ventilated area only.
Do not expose Boost 200 to moisture and use it in extremely hot conditions.
Monitor the pressure gauge during use. Be careful not to over-inflate objects.
Never work alone with this product. Make sure that someone is available to give assistance if need-
ed.
Wear complete eye and clothing protection. Do not touch eyes while working near battery.
Do not attempt to remove or replace the battery used in this device. When the battery has reached
the end of its useful lifetime, take the entire unit to a battery recycling facility.
For proper and safe operation of the 12 Volt DC power accessory outlets, do not place anything into
it except the plug of the accessory to be used.
Remove metal, personal jewelry, such as: rings, bracelets, necklaces and watches, while working
with a lead acid battery. This can produce a short-circuit that may cause severe burns.
Never charge or jump-start a frozen battery.
Do not operate this device while wearing vinyl clothing. Static electricity may be generated when
vinyl clothing is rubbed.
This product is not intended for use in the rain or temperatures above 150ºF.
Use only the provided chargers, cables and clamps. Unauthorized parts may damage the unit.
This product has no consumer serviceable parts except the replaceable fuses.
Keep out of the reach of children.
Keep battery terminals clean. Be careful to keep corrosion from coming in contact with eyes.
Do not let the cords of the Boost 200 or jumper clamps get wet.
Prevent water to get into Boost 200 housing. Water will damage the internal electronics board.
This unit has a built-in lead acid battery. Although Boost 200 arrives partially charged from the
factory, it MUST be fully charged before the first use.
Recharge Boost 200 after each use or every 3 months preventing the battery voltage to become
extremely low.
FEATURES:
Compact 6-1 multipurpose AC and DC power supply with vehicle jumpstart boosting system. The unit
provides: two 12 VDC covered output ports, 200 Watt continuous power inverter with 120 VAC covered
outlet, 260 PSI air compressor, Booster Cables with Insulated Clamps, Booster Cables Power Switch,
Nozzle Adaptors for most Inflatables, LED working light, Battery Status Needle Dial Gauge, USB power
port with vehicle instant battery jump starter.
Model No. 2032
S
he
et
2
of
9
