FITTING THE WHEELS
6
Fitting the front wheel:
Slot the front wheel
assembly onto the front of
the pushchairs frame.
Ensure that the threaded
bolts are protruding
through the attachment
plate of the pushchair.
Slot the washers onto the
ends of the threaded bolt.
Tighten the two nuts onto
the bolts using the
spanner provided.
Fitting the rear wheels:
Slot the pin on the wheel
into the hole in the end of
the rear axle.
Release the button once
you have pushed the pin in
as far as it will go.
Test the wheel is correctly
fitted by attempting to
pull it off again.
If the wheel comes off
repeat the procedure.
Align the sockets on the
front wheel with the forks
as shown in the diagram.
Push the sockets onto the
forks as far as they will
go.
Place the front wheel on
the ground until the wheel
locks into place.
Check that the two metal
studs are protruding
through the holes in the
front wheel sockets.
