•
Output
•
Stereo Pan
Use this knob to adjust the stereo panning of Bandpass1 and Bandpass3.
Bandpass2 is equally distributed on the right and left outputs.
Knob position left: Bandpass1 -> left, Bandpass3 -> right Knob
position right: Bandpass1 -> right, Bandpass3 -> left Knob
position middle: Mono mode
•
Resonance
Determines the ratio between the original and the effect signal
•
Volume
Adjusts the volume at the output of the RS3 (Bypass OFF)
•
Bypass
ON: The input signal is switched to the output without change.
OFF: The effect signal is present at the output of the RS3.
•
Frequency
With these controllers, the center frequency of the bandpass filters 1, 2 and 3
can be set individu- ally.
•
LFO Modulation
‡
RATE
Speed of the LFO (0.01Hz-2Hz)
‡
Depth
Intensity of LFO modulation
‡
Mode
The RS3 has 3 different LFO sources: LFO1, LFO2 and LFO1 inverted. LFO 1
and 2 have a sawtooth waveform, but have a different speed (LFO 2 is about
30% faster than LFO1.
With the mode switch, these are assigned to the individual bandpasses in
various combinations, which allows different stereo effects to be achieved
(maximum stereo depth in mode 3).
Mode 1: LFO1 -> Bandpass 1,2 3
Mode 2: LFO1 -> Bandpass 1,3
LFO2 -> Bandpass 2
Mode 3: LFO1 -> Bandpass 1
LFO1 inverted -> Bandpass 2
LFO2 -> Bandpass3
•
ENV Modulation
The RS3 has 3 mutually independent envelope followers that respond to
different frequency ranges (LOW, MID and HIGH) of the input signal. Envelope
followers act on the bandpass as follows:
Envelope-Follower1 (LOW) -> Bandpass1
Envelope-Follower2 (MID) -> Bandpass2
Envelope-Follower2 (HIGH) -> Bandpass3
The bandpass frequencies thus change depending on the sound and
dynamics of the input signal. This effect is particularly impressive in stereo
mode (stereo pan left or right).
• Depth
Regulates the strength of the ENV modulation for all band pass
collectively.
· Decay
Evelope followers respond very quickly to changes in the input signal (short
attack time). The decay time (Decay) can be changed with the help of the decay
control.
‡
Polarity
+
:
The envelope followers shift the bandpass frequencies up.
- :
The envelope followers shift the bandpass frequencies down.
•
MAN/EXT Modulation
The operation of this controller depends on whether the external modulation
input is connected or not.
• Input not connected:
Manual control of bandpass frequencies 1,2 and 3.
• Input connected:
Summary of Contents for RS3
Page 1: ...Operation Manual RS3...
