Controls Of The RS3
Front View
5•FNDQVLFKW
Input
:
Stereo Pan:
Resonance:
Volume:
Bypass:
Frequency:
LFO Rate:
LFO Depth:
LFO Mode:
ENV Modulation:
ENV Depth:
ENV Decay:
ENV Polarity:
Man/Ext Input:
Mod Input:
Mod Input:
Audio Mono Input
This knob adjusts the stereo panning of Bandpass1 and Bandpass3. Bandpass2 is distributed equally to the right and left output.
Determines the ratio between the original and the effect
ed
signal
Volume at the output of the RS3 (Bypass OFF)
ON: The input signal is switched to the output without change. OFF: The effect signal is present at the output of the RS3.
With these controllers the center frequency of the bandpass 1,2 and 3 can be adjusted individually.
Speed of the LFO (0.01Hz-2Hz)
Intensity of LFO modulation
Mode 1: LFO1 -> Bandpass 1.2 3 / Mode 2: LFO1 -> Bandpass 1.3; LFO2 -> Bandpass 2 / M ode 3: LFO1 -> Bandpass 1; LFO1 inverted -> bandpass 2; LFO2 -> Bandpass3
Envelope-Follower1 (LOW) -> Bandpass1, Envelope-Follower2 (MID) -> Bandpass2, Envelope-Follower2 (HIGH)
Regulates the strength of the ENV modulation for all band pass collectively.
The
envelope
decay time can be changed with the help of the decay control.
(+) Envelope followers shift bandpass frequencies up. (-) The envelope followers shift the bandpass frequencies down.
The operation of this controller depends on whether the external modulation input is connected or not.
Input unconnected: Manual control of the bandpass frequencies 1,2 and 3.
Input connected: The bandpass frequencies are now modulated by an external control voltage.
02'8/$7,21ã
$&ýìëý92/7
OHIWî6WHUHRã
ULJKWã
,QSXWã
Connection. an external voltage (0-10V) for common modulation of the bandpass frequencies. If both sockets are connected, only the input on the front side is active.
Anschlur. des externen Netzteils (12Volt, AC, 700 mA)
Connection. the external power supply (12V, AC, 700mA)
Right mono output
Audio mono input
Summary of Contents for RS3
Page 1: ...Operation Manual RS3...
